Brother 884-T79 Manuel D'instructions page 15

8 Place the thread end so that it does
not protrude from the bobbin.
7 While holding the end of the thread,
press on the foot controller for a
few seconds. Once enough thread
has wound itself around the bobbin
to hold itself in place, release the
foot controller and trim the excess
thread.
A Cut thread and remove bobbin.
Press down
Pedal
Foot controller
Pressing down on the foot controller
8
harder increases the winding speed.
8 Start winding the bobbin again
by pressing down on the foot
controller.
9 Stop winding process when bobbin
is full. Remove your foot from the
foot controller.
Bobbin Winding Clutch
0 Manually move bobbin winding
clutch back to original position.
13