To Stop The Product - Husqvarna K1270 II Manuel D'utilisation

2. Make sure that the STOP switch is in the left
position.
3. Pull the choke control fully to get the start throttle
position.
4. Push the choke control to disable the choke. The
start throttle stays in position.
5. Hold the front handle with your left hand.
6. Put your right foot on the lower section of the rear
handle to push the product against the ground.
988 - 001 - 21.10.2019
WARNING: Do not wind the starter rope
around your hand.
7. Pull the starter rope slowly until you feel a resistance
as the starter pawls engage. Then pull continuously
and quickly.
CAUTION: Do not pull the starter rope
fully and do not let go of the starter rope
handle when the starter rope is
extended. This can cause damage to the
product.
8. Push the throttle trigger to disengage the start
throttle and set the product at idle speed.

To stop the product

WARNING: The cutting blade continues to
rotate for a while after the engine stops.
Make sure that the cutting blade can rotate
freely until it fully stops. If it is necessary to
stop the cutting blade quickly, let the cutting
blade lightly touch a hard surface. Risk of
serious injury.
65