To Fill Fuel - Husqvarna K1270 II Manuel D'utilisation

Masquer les pouces Voir aussi pour K1270 II:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Two-stroke oil
For best results and performance use Husqvarna
two-stroke oil.
If Husqvarna two-stroke oil is not available, use a
two-stroke oil of good quality for air-cooled engines.
Speak to your servicing dealer to select the correct
oil.
CAUTION: Do not use two-stroke oil for
water-cooled outboard engines, also
referred to as outboard oil. Do not use oil
for four-stroke engines.
Premixed fuel
Use Husqvarna premixed alkylate fuel of a good
quality, for best performance and extension of the
engine life. This fuel contains less harmful chemicals
compared to regular fuel, which decreases harmful
exhaust fumes. The quantity of remains after
combustion is lower with this fuel, which keeps the
components of the engine more clean.
To mix gasoline and two-stroke oil
Gasoline, liter
5
10
15
20
US gallon
1
2 1/2
5
CAUTION: Small errors can influence the
ratio of the mixture drastically when you mix
small quantities of fuel. Measure the quantity
of oil carefully and make sure that you get
the correct mixture.
62
1. Fill half the quantity of gasoline in a clean container
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
5. Carefully shake the fuel mixture.
Two-stroke oil,
liter

To fill fuel

2% (50:1)
0.10
0.20
0.30
0.40
US fl. oz.
Note: Carburetor adjustment is in some conditions
2 ½
necessary when you change the type of fuel.
6 ½
12 ⅞
1. Open the fuel tank cap slowly to release the
2. Fill slowly with a fuel can. If you spill fuel, remove it
3. Clean the area around the fuel tank cap.
4. Tighten the fuel tank cap fully. If the fuel tank cap is
5. Move the product a minimum of 3 m (10 ft) from the
for fuel.
container.
CAUTION: Do not mix fuel for more than 1
month at a time.
CAUTION: Do not use gasoline with an
octane number less than 90 RON (87 AKI).
It causes damage to the product.
CAUTION: Do not use gasoline with more
than 10% ethanol concentration (E10). It
causes damage to the product.
Use gasoline with a higher octane number if you
frequently use the product at continuously high
engine speed.
pressure.
with a cloth and let the remaining fuel dry off.
not tightened, there is a risk of fire.
position where you filled the tank before a start.
988 - 001 - 21.10.2019

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

K1270 ii rail

Table des Matières