Husqvarna K1270 II Manuel D'utilisation page 66

• Move the STOP switch to the right to stop the
engine.
Rail cutting (K1270 II Rail)
General
CAUTION: Do not install the rail fixture on
the product during transport or when you
move the product. When the product and the
rail fixture are put together, there is a larger
risk of damage than when they are
disconnected. Damages, such as bent parts,
can result in less accurate cuts.
To install the rail fixture
CAUTION: Install the rail fixture to the rail
before you install the product to the rail
fixture. There is a risk that the rail fixture is
not installed at a correct angle if the product
is installed first.
66
1. Attach the rail fixture to the rail. Tighten the handle
fully.
2. Install the product on the rail fixture with the right
side of the product against the rail fixture.
Note: It is also possible to install the product with the left
side against the rail fixture, but we recommend to use
the right side when possible.
To prepare the cutting guide
Note: The first time you use the rail system, you must
cut the cutting guide.
The cutting guide helps the operator to put the cutting
blade in correct position for the cut.
1. Fold out the cutting guide.
2. Put the cutting guide parallel to the rail.
3. Carefully cut off the cutting guide.
To use the rail fixture
1. Fold out the cutting guide.
2. Align the saw cut and fold in the cutting guide.
988 - 001 - 21.10.2019