Husqvarna K1270 II Manuel D'utilisation page 64

7. Pull the starter rope slowly with your right hand until
you feel a resistance as the starter pawls engage.
Then pull continuously and quickly.
CAUTION: Do not pull the starter rope
fully and do not let go of the starter rope
handle when the starter rope is
extended. This can cause damage to the
product.
8. Push the choke control when the engine starts. If the
choke is pulled out, the engine will stop after some
seconds. If the engine stops, pull the starter rope
handle again.
64
9. Push the throttle trigger to disengage the start
throttle and set the product at idle speed.
To start the product with a warm engine
WARNING: Make sure that the cutting blade
can rotate freely. It starts to rotate when the
engine starts.
1. Push the decompression valve to decrease the
pressure in the cylinder. The decompression valve
goes back to its initial position when the product
starts.
988 - 001 - 21.10.2019