To Stop The Product; Maintenance; Maintenance Schedule - Husqvarna K 770 Manuel D'utilisation

8. Push the throttle trigger to disengage the start
throttle and set the product at idle speed.

To stop the product

WARNING:
continues to rotate for a while after the
engine stops. Make sure that the cutting
blade can rotate freely until it fully stops. If it
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
For all servicing and repair work on the product, special
training is necessary. We guarantee that professional
repairs and servicing is available. If your dealer is not a
Clean
Function inspection
Replace
Safety devices on the product on page 10 .
* Refer to
** Refer to Cutting blades on page 12 .
To clean externally
• Flush the product externally with clean water after
each day of operation. If it is necessary, use a brush.
1447 - 004 - 04.05.2021
The cutting blade

Maintenance

Read and understand the
Daily
External cleaning
Cold air intake
General inspection
Fuel leaks
Water delivery system
Throttle lockout*
Stop switch*
Blade guard and SmartGuard*
Cutting blade**
is necessary to stop the cutting blade
quickly, let the cutting blade lightly touch a
hard surface. Risk of serious injury.
• Move the STOP switch to the right to stop the
engine.
service agent, speak to them for information about the
nearest service agent.
For spare parts, speak to your HUSQVARNA dealer or
service agent.

Maintenance schedule

The maintenance schedule shows the necessary
maintenance of the product. The intervals are calculated
on daily use of the product.
Weekly
Vibration damping system*
Muffler*
Drive belt
Carburetor
Starter housing
Monthly Yearly
Spark plug
Fuel tank
Fuel system
Air filter
Clutch
Fuel filter
27