Problem
There is much dust during
operation. You can see dust
in the air.
The SmartGuard does not
move freely.
The SmartGuard does not re-
tract when the product is re-
moved away from the work
piece.
Transportation and storage
•
Safely attach the product during transportation to
prevent damage and accidents.
•
Remove the cutting blade before transportation or
storage of the product.
•
Keep the product in a locked area to prevent access
for children or persons that are not approved.
•
Keep the cutting blades in dry, frost free conditions.
•
Examine all new and used blades for transport and
storage damage before assembly.
•
Clean and maintain the product before storage.
Maintenance on page 27 .
Refer to
•
Remove the fuel from the fuel tank before long-term
storage.
Disposal
•
Obey the local recycling requirements and applicable
regulations.
•
Discard all chemicals, such as oil or fuel, at a service
center or at an applicable disposal location.
•
When the product is no longer in use, send it to a
HUSQVARNA dealer or discard it at a recycling
location.
1447 - 004 - 04.05.2021
Cause
The water supply or water pressure
is not sufficient.
The moving parts of the SmartGuard
are clogged.
The springs of the SmartGuard does
not operate correctly.
Transportation, storage and disposal
Possible solutions
Do a check of the water supply to the prod-
uct.
To do a check of the water supply
Refer to
system on page 33 .
Clean the moving parts.
Do a check of the springs. Clean the springs.
35