Danby DDW1801MW Instructions D'installation page 8

Option 1 - Waste disposer – with air gap:
1. Remove the disposer knockout plug. Cut end of drain hose
if needed (do not cut ribbed section).
2. Attach drain hose to air gap with large spring-type clamp.
If the drain hose was cut, use a 1-1/2" to 2" (3.8 to 5 cm)
screw-type clamp*.
3. Use a rubber hose connector* with spring or screwtype
clamps* to connect air gap to disposer inlet.
This connection must be before the drain trap and at least 20"
(50.8 cm) above the fl oor where dishwasher will be installed.
4. Insert drain hose through hole cut in cabinet to the front
center of opening where drain connection will be made.
* Parts should be available from a local plumbing supply store.
Option 2 - No waste disposer – with air gap:
1. Cut end of drain hose if needed (do not cut ribbed section).
2. Attach drain hose to air gap with large spring-type clamp.
If the drain hose was cut, use a 1-1/2" to 2" (3.8 to 5 cm)
screw-type clamp*.
3. Use a rubber hose connector* with spring or screw type
clamps* to connect air gap to waste tee. This connection
must be before the drain trap and at least 20" (50.8 cm)
above the fl oor where dishwasher will be installed.
4. Insert drain hose through hole cut in cabinet to the front
center of opening where drain connection will be made.
All manuals and user guides at all-guides.com
INSTALLATION INSTRUCTIONS
Drain Hose - Cut here
if needed
Spring or screw-type
clamps
Drain tap
Drain Hose - Cut here
if needed
Spring or screw-type
clamps
Drain tap
6
Rubber hose con-
nector
Air Gap
Large spring-type
clamp
Drain hose
Drain Hose
Rubber hose con-
Air Gap
nector
Large spring-type
clamp
Waste Drain hose
Tee
Drain hose