Télécharger Imprimer la page

Danby DDW1801MW Instructions D'installation page 11

Masquer les pouces Voir aussi pour DDW1801MW:

Publicité

Les langues disponibles

Les langues disponibles

Install the Drain Hose
IMPORTANT: Always use a new drain hose.
1. Drill a 1-1/2" (3.8 cm) diameter hole in cabinet wall or fl oor on the side of the
opening closest to the sink.
2. Connect drain hose to waste tee or waste disposer using one of the following
methods:
Option 1, Waste disposer – with air gap
Option 2, No waste disposer – with air gap
Option 3, Waste disposer – no air gap*
Option 4, No waste disposer – no air gap*
*an air gap is recommended
Helpful Tip: To reduce the vibration of the hose, keep the hose away from
the fl oor and the edge of the hole where it passes through the cabinet.
Option 1 - Waste disposer – with air gap:
1. Remove the disposer knockout plug. Cut end of drain
hose if needed (do not cut ribbed section).
2. Attach drain hose to air gap with large spring-type clamp.
If the drain hose was cut, use a 1-1/2" to 2" (3.8 to 5 cm)
screw-type clamp*.
3. Use a rubber hose connector* with spring or screw type
clamps* to connect air gap to disposer inlet. This connec-
tion must be before the drain trap and at least 20" (50.8
cm) above the fl oor where dishwasher will be installed.
4. Insert drain hose through hole cut in cabinet to the front
center of opening where drain connection will be made.
* Parts should be available from a local plumbing supply store.
Option 2 - No waste disposer – with air gap:
1. Cut end of drain hose if needed (do not cut ribbed sec-
tion).
2. Attach drain hose to air gap with large spring-type clamp.
If the drain hose was cut, use a 1-1/2" to 2" (3.8 to 5 cm)
screw-type clamp*.
3. Use a rubber hose connector* with spring or screwtype
clamps* to connect air gap to waste tee. This connection
must be before the drain trap and at least 20" (50.8 cm)
above the fl oor where dishwasher will be installed.
4. Insert drain hose through hole cut in cabinet to the front-
center of opening where drain connection will be made.
* Parts should be available from a local plumbing supply store.
All manuals and user guides at all-guides.com
INSTALLATION INSTRUCTIONS
Drain Hose - Cut here
if needed
Spring or screw-type
clamps
Drain tap
Drain Hose - Cut here
if needed
Spring or screw-type
clamps
Drain tap
9
Rubber hose con-
nector
Air Gap
Large spring-type
clamp
Drain hose
Drain Hose
Rubber hose con-
Air Gap
nector
Large spring-type
clamp
Waste
Drain hose
Tee
Drain hose

Publicité

loading

Ce manuel est également adapté pour:

Ddw1802ebls