Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION REQUIREMENTS
Location Requirements:
•
Do not run drain lines, water lines or electrical wiring where they can interfere with or contact dishwasher motors or
legs.
•
The location where the dishwasher will be installed must provide clearance between motors and fl ooring. Motors
should not touch the fl oor.
•
Do not install dishwasher over carpeted fl ooring. Protect dishwasher and water lines leading to dishwasher against
freezing. Damage from freezing is not covered by the warranty.
Check location where dishwasher will be installed. The location must provide:
1. Easy access to water, electricity and drain.
2. Convenient access for loading and unloading dishes. Corner locations require a 2" (5.1 cm) minimum clearance be-
tween the side of the dishwasher door and the wall or cabinet.
3. There must be a minimum of 25-5/8" (65.1 cm) in front of dishwasher to allow door to open fully.
4. Square opening for proper operation and appearance.
5. Cabinet front perpendicular to fl oor.
6. Level fl oor. (If fl oor at front of opening is not level with fl oor at rear of opening, shims may be needed to level dish-
washer.) NOTE: To prevent shifting during dishwasher operation, shims must be securely attached to the
fl oor.
If dishwasher will be left unused for a period of time or in a location where it may be subject to freezing, have it winterized
by authorized service personnel.
Make sure pipes, wires and drain hose are within the shaded area shown in the "Cutout dimensions" section.
Helpful Tip: If the fl oor in the dishwasher opening is uneven (example: tile fl ooring only partway into opening)
you will need to take special care in measuring dimensions and in leveling dishwasher.
All manuals and user guides at all-guides.com
Countertop
Dishwasher
2" ( 5.1 cm)
Clearance for door
opening minimum
2
25-5/8"
( 65.1 cm)
Publicité
