Publicité
Les langues disponibles
Les langues disponibles
Option 2 - Power Supply Cord Method
WARNING:
•
Plug into a grounded 3 prong outlet.
•
Do not remove ground prong.
•
Do not use an adapter.
•
Do not use an extension cord.
•
Failure to follow these instructions can result in death, fi re, or electrical shock.
The power cord and connections must comply with the National Electrical Code, Section 422 and/or local codes and ordi-
nances. Recommended power cord length is 54" min. and 64" max.
1. Remove terminal box cover.
2. Connect incoming power cord white (or ribbed) wire to dishwasher white wire, black (or smooth) wire to black wire and
ground wire to dishwasher green wire. Use UL listed wire nuts of the appropriate size for connections.
3. Replace terminal box cover. Make sure wires are not pinched under the cover.
4. Plug power cord into a grounded 3 prong outlet.
5. Check the power supply cord does not touch dishwasher motor or lower part of dishwasher tub.
Connect to Water Supply
Helpful Tips - Compression fi ttings:
•
Slide nut onto copper tubing about 1" (2.5 cm).
•
Slide ferrule onto the tubing. Do not position ferrule on the end of the tubing.
•
Put the tubing into the elbow as far as it will go.
•
Slide the nut and ferrule forward and start the nut onto the elbow threads. Be gentle when handling and positioning
the copper tubing, it bends and kinks easily.
1. To prevent vibration during operation, route the water supply line so that it does not touch the dishwasher base, frame
or motor.
2. With copper tubing pushed into compression fi tting as far as it will go, use a wrench and tighten compression fi tting
nut to elbow on water inlet valve. Do not use Tefl on® tape with compression fi ttings.
3. Place paper towel under elbow. Turn on water supply and check for leaks.
All manuals and user guides at all-guides.com
INSTALLATION INSTRUCTIONS
Electrical Shock Hazard
Elbow
Nut
Ferrule
15
Publicité
