Publicité
Les langues disponibles
Les langues disponibles
Connecting the Drain
1. To help minimize vibration, route drain hose to avoid contact with motor, door springs, water line, cabinet, fl ooring or
the edge of the hole where it passes through the cabinet.
2. Do not remove drain loop from side of dishwasher.
3. Place pan under end of drain hose. Pan will collect any water in drain hose.
4. The drain hose molded end will fi t 5/8" (16mm), 3/4" (19mm) or 1" (25.4mm) diameter connections on the air gap,
waste tee or disposer. Cut on the marked line as required for your installation.
IMPORTANT: Do not cut corrugated portion of hose. If a longer drain hose is required, add up to 42"(1.07m) of length for a
total of 10 ft (3.05m) to the factory installed hose.
5. Use 5/8" or 7/8" inside diameter hose and a coupler to connect the two hose ends. Secure the connection with hose
clamps. Secure the drain hose to the air gap, waste tee or disposer with clamps.
NOTE: Total drain hose length must not exceed 10 ft (3.05m), for proper drain operation.
All manuals and user guides at all-guides.com
INSTALLATION INSTRUCTIONS
Cutting
lines
1"
3/4"
Heat
Clamp
Drain
Hose
5/8"
Coupler
Hose
Clamp
16
Publicité
