Télécharger Imprimer la page

Danby DDW1801MW Instructions D'installation page 10

Masquer les pouces Voir aussi pour DDW1801MW:

Publicité

Les langues disponibles

Les langues disponibles

Prepare Cabinet Opening Where There are no Existing Utility Hookups
Electrical Connection:
Option 1 - Direct Wire Method:
Helpful Tip: Wiring the dishwasher will be easier if you route wire into the
cabinet opening from the right side.
1. Drill a 3/4" (1.9 cm) hole in right-hand cabinet side, rear or fl oor. Preferred and
optional locations are shown.
2. Wood cabinet: Sand hole until smooth. Metal cabinet: Cover hole with grom-
met, not provided.
3. Run wire into house wiring junction box.
4. Install a UL listed/CSA certifi ed clamp connector (strain relief) for fl exible-type
wire. If installing conduit, attach a UL listed/CSA certifi ed conduit connector to
the junction box.
5. Run other end of wire through cabinet hole. Cable must extend to the right
front of cabinet opening.
Option 2 - Power Supply Cord Method:
NOTE: A mating, three prong, ground-type wall receptacle is required in a
cabinet next to the dishwasher opening.
1. Drill a 1-1/2" (3.8 cm) hole in the cabinet rear or side. Preferred and optional
locations are shown.
2. Wood cabinet: Sand hole until smooth.
3. Metal cabinet: Cover hole with grommet.
Install the Water Line:
Helpful Tip: Routing the water line through the left side of
cabinet opening will make water connection easier.
1. Drill a minimum 1/2" (1.3 cm) hole in the cabinet side, rear
or fl oor. Preferred and optional locations are shown.
2. Measure overall length of copper tubing required.
3. Attach copper tubing to the water line with a manual shutoff
valve.
4. Slowly feed copper tubing through hole in cabinet. Copper
tubing will bend and kink easily, so be gentle. The copper
tubing should be far enough into the cabinet opening to
connect it to dishwasher inlet on the front left of the dish-
washer.
5. Turn water shutoff valve to "ON" position. Flush water into
a shallow pan to get rid of particles that may clog the inlet
valve.
6. Turn shutoff valve to "OFF" position.
All manuals and user guides at all-guides.com
INSTALLATION INSTRUCTIONS
Preferred
Locations
8
Option-
Preferred
al Loca-
Locations
tions
Option-
Preferred
al Loca-
Locations
tions
Optional
Locations
Copper
Tubing

Publicité

loading

Ce manuel est également adapté pour:

Ddw1802ebls