Publicité
Les langues disponibles
Les langues disponibles
Prepare Dishwasher:
WARNING:
Tip Over Hazard
•
Do not use dishwasher until completely installed.
•
Do not push down on open door.
•
Doing so can result in serious injury or cuts.
Helpful Tip: Put cardboard under dishwasher until it is installed in cabinet opening. The cardboard will help protect fl oor
covering during installation.
1. Grasp sides of dishwasher door frame and put dishwasher on its back.
2. Remove four screws attaching toekick panel and lower panel to dishwasher using a 1/4" hex socket, nut driver or
Phillips screwdriver.
3. Remove panels and set panels aside on a protective surface.
4. Apply thread seal tape to 90° elbow fi tting and connect fi tting to water inlet valve.
5. Tighten elbow until snug, and be sure that it faces to the rear.
6. Remove terminal box cover. – If you are direct wiring: install a U.L.-listed/CSA certifi ed clamp connector to the ter-
minal box. If using conduit, use a U.L.-listed/CSA-certifi ed conduit connector. – If you are installing a power supply
cord kit, do so now, following kit instructions. The power supply cord kit must be U.L.-listed and marked for use with
dishwashers.
7. Measure height of cabinet opening from underside of countertop to fl oor where dishwasher will be installed (you need
the lowest point).
8. Extend leveling legs out from the dishwasher base, 1/4" less than opening height.
All manuals and user guides at all-guides.com
INSTALLATION INSTRUCTIONS
4 toekick
screws
WARNING:
Excessive Weight Hazard
•
Use two or more people to move and install dish-
washer.
•
Failure to do so can result in back or other injury.
Levelling
Leg
11
Water inlet
valve
Elbow
Publicité
