Microbiological Examination Of Decentralized Disinfectant Metering Units - Ecolab DG1-III-DLA-PCB Manuel D'utilisation

Safety
Obligations of the operator
Valid guidelines
In the EEA (European Economic Area), national implementation of the
Directive (89/391/EEC) and corresponding individual directives, in particular
the Directive (2009/104/EC) concerning the minimum safety and health
requirements for the use of work equipment by workers at work, as
amended, are to be observed and adhered to.
If you are outside the EEA (European Economic Area), the local regulations
always apply. However, it is important to make sure that the EEA rules do
not apply to your area, due to special agreements.
The operator is responsible for checking the terms and conditions
that affect you.
The operator must adhere to the local legal provisions for:
n The safety of personnel (within the Federal Republic of Germany, in particular the
federal law and accident prevention regulations, workplace guidelines, e.g. operating
instructions, also according to Section 20 Hazardous Substances Ordinance
(GefStoffV), personal protective equipment (PPE), preventive investigations)
n The safety of work materials and tools (protective equipment, work instructions,
procedural risks and maintenance)
n Product procurement (safety datasheets, list of hazardous substances)
n Disposal of products (Waste Act)
Disposal of materials (decommissioning, Waste Act)
n
n Cleaning (detergents and disposal)
n and observe current environment protection regulations.
The owner is also required to:
n Provide personal protective equipment (PPE)
n Incorporate the measures into operating instructions and to instruct personnel
accordingly
n For operating sites (from 1m above ground) To provide safe access
n The operator must provide lighting in workplaces in accordance with DIN EN 12464-1
(within the Federal Republic of Germany). Observe the local applicable regulations!
n To ensure that local regulations are complied with during installation and
commissioning, if these procedures are conducted by the operator
2.6

Microbiological examination of decentralized disinfectant metering units

Responsibility for the correct operation of the metering unit in accordance with the RKI
guidelines on "Design criteria, properties and operation of decentralized disinfectant
metering units" (Federal Health Bulletin 2004 . 47: 67-72).
The annually required hygienic-technical inspections are described in the operating and
assembly instructions of the dosing units in the item Maintenance.
If the end user conducts a test for a situation-related hygienic-microbiological verification
of the metering device, Ecolab suggests the process described in RKI recommendation
"Requirement for hygiene in the cleaning and disinfection of surfaces" (Federal Health
Bulletin 2004-47: 51-61, point 4.5) implemented, this should be carried out as described in
Ä Chapter 10.1 'Specifications for microbiological testing of decentralised disinfectant
dispensers' on page 44.
MAN049250 Rev. 1-01.2021 16