Ecolab DG1-III-DLA-PCB Manuel D'utilisation page 110

Operation
Connecting the thermostatic mixer tap
Installation:
NOTICE!
A thermostatic mixer tap must be installed in accordance with standard
regulations and should therefore be conducted by a specialist contractor.
Make sure that the connections are correctly assigned:
– + = hot water connection
– - = hot water connection
– ► = hot water connection
The mixer tap can optionally be connected via a G ½ stainless steel flex hose
or Ø 10 x 1 copper pipe.
Connection by means of copper pipe:
1.
Connect the copper pipe Ø 10 x 1 to the compression fitting.
2.
Tighten the screw fitting with a spanner wrench.
Connection stainless steel flex hose G1/2:
1.
Unscrew the reducing fitting.
2.
Connect the stainless steel flexible hose to the G½ external thread.
Temperature setting:
1
Fig. 5: Thermo mixer tap temperature adjustment
1.
Turn the cap to the marking (pos. 1).
2.
Lift off the cap (pos. 2).
3.
Adjust the knurled wheel (Pos.3) until the desired temperature is reached.
4.
Place the cap back on to secure against adjustment.
MAN049250 Rev. 1-01.2021
3
2
38