Transportation; Transport Inspection; Packaging - Ecolab DG1-III-DLA-PCB Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

General remarks
1.2

Transportation

The measurements of the packaging and the weight of the packaging can be found online
Ä Section 12 "Technical data" on page 60.
NOTICE!
Material damage due to improper transportation!
– Transport units can fall or tip over if improperly transported. This can
cause a large amount of damage. When unloading the shipping crates,
during delivery or even during general shipping, proceed safely and pay
attention to the symbols and the information on the packaging.
Danger of putting into operation a piece of transport equipment which
has been damaged during transport:
– If damages are discovered during unpacking, do not install or put unit
into operation, as otherwise uncontrollable faults can occur.

Transport inspection:

– Examine delivery for completeness and transportation damages and
report every damage.
– Damage claims can only be filed within the applicable period for
complaints.
In event of transportation damages visible from the outside:
– Do not accept the delivery or accept provisionally.
– Note the extent of damage on transport documents Delivery note of the
carrier and initiate a complaint immediately.
1.3

Packaging

The individual packages are bundled to suit the expected transport conditions.
Only environmentally-friendly materials have been used in the packaging.
The packaging is designed to protect the individual components against shipping damage,
corrosion and other damage before assembly.
Do not destroy the packaging and only remove it just before assembly.
There may be instructions on how to handle the packages (e.g. this way up,
fragile, keep dry). These must be adhered to accordingly.
ENVIRONMENT!
Risk of environmental damage from incorrect disposal!
Packaging materials are valuable raw materials and can, in many cases, be
used again or be usefully processed and recycled.
Incorrect disposal of packaging materials can be a threat to the
environment.
– Observe the local disposal regulations!
– Environmentally-friendly disposal of packaging materials.
– If necessary, hire a specialist to carry out disposal.
MAN049250 Rev. 1-01.2021
8

Publicité

Table des Matières
loading

Produits Connexes pour Ecolab DG1-III-DLA-PCB

Table des Matières