Publicité
OIL FILTER, WATER PUMP AND CRANKCASE COVER
All manuals and user guides at all-guides.com
EC4G5220
Impeller shaft
NOTE:
G
G
G
Crankcase cover (right)
NOTE:
G
G
G
4 - 57
(RIGHT)
1. Install:
Impeller shaft 1
G
Plain washer 2
G
Impeller 3
G
14 Nm (1.4 m · kg, 10 ft · lb)
Take care so that the oil seal lip is not dam-
aged or the spring does not slip off its posi-
tion.
When installing the impeller shaft, apply the
engine oil on the oil seal lip, bearing and
impeller shaft. And install the shaft while
turning it.
Hold the impeller shaft on its width across
the flats a with spanners, etc. and install the
impeller.
1. Install:
Dowel pin 1
G
O-ring 2
G
Collar 3
G
Gasket 4
New
G
2. Install:
Crankcase cover (right) 1
G
Bolt
10 Nm (1.0 m · kg, 7.2 ft · lb)
G
Apply the engine oil on the impeller shaft
end.
When installing the crankcase cover onto the
crankcase, be sure that the impeller shaft
end 2 aligns with the balancer end slot 3.
Tighten the bolts in stage, using a crisscross
pattern.
ENG
Publicité
