Publicité
All manuals and user guides at all-guides.com
CYLINDER AND PISTON
Piston ring
NOTE:
Clean carbon from the piston ring grooves and
rings before measuring the side clearance.
NOTE:
Insert a ring into the cylinder and push it
approximately 10 mm (0.39 in) into the cylin-
der. Push the ring with the piston crown so that
the ring will be at a right angle to the cylinder
bore.
a 10 mm (0.39 in)
NOTE:
You cannot measure the end gap on the
expander spacer of the oil control ring. If the oil
control ring rails show excessive gap, replace
all three rings.
4 - 43
1. Measure:
Ring side clearance
G
Use a feeler gauge 1.
Out of specification → Replace the pis-
ton and rings as a set.
Side clearance:
Standard
0.030 ~ 0.065 mm
Top ring
(0.0012 ~ 0.0026 in)
0.020 ~ 0.055 mm
2nd ring
(0.0008 ~ 0.0022 in)
2. Position:
Piston ring
G
(in cylinder)
3. Measure:
Ring end gap
G
Out of specification → Replace.
End gap:
Standard
0.20 ~ 0.30 mm
Top ring
(0.008 ~ 0.012 in)
0.35 ~ 0.50 mm
2nd ring
(0.014 ~ 0.020 in)
0.20 ~ 0.50 mm
Oil ring
(0.01 ~ 0.02 in)
ENG
<Limit>
0.12 mm
(0.005 in)
0.12 mm
(0.005 in)
<Limit>
0.55 mm
(0.022 in)
0.85 mm
(0.033 in)
—
Publicité
