Publicité
All manuals and user guides at all-guides.com
IMPORTANT INFORMATION
EC132000
ALL REPLACEMENT PARTS
EC133000
GASKETS, OIL SEALS AND O-RINGS
EC134000
LOCK WASHERS/PLATES AND COTTER
PINS
EC135001
BEARINGS AND OIL SEALS
Do not use compressed air to spin the
bearings dry. This causes damage to the
bearing surfaces.
1 - 4
1. We recommend to use Yamaha genuine
parts for all replacements. Use oil and/or
grease recommended by Yamaha for
assembly and adjustment.
1. All gaskets, oil seals, and O-rings should
be replaced when an engine is over-
hauled. All gasket surfaces, oil seal lips,
and O-rings must be cleaned.
2. Properly oil all mating parts and bearings
during reassembly. Apply grease to the
oil seal lips.
1. All lock washers/plates 1 and cotter pins
must
be
replaced
removed. Lock tab(s) should be bent
along the bolt or nut flat(s) after the bolt
or nut has been properly tightened.
1. Install the bearing(s) 1 and oil seal(s) 2
with their manufacturer's marks or num-
bers facing outward. (In other words, the
stamped letters must be on the side
exposed to view.) When installing oil
seal(s), apply a light coating of light-
weight lithium base grease to the seal
lip(s). Oil the bearings liberally when
installing.
CAUTION:
GEN
INFO
when
they
are
Publicité
