Hitachi C 6DC2 Instructions De Sécurité Et Mode D'emploi page 24

English
REPLACING LIGHT BULB
WARNING:
Make absolutely sure that the battery is removed from the main body before
replacing the light bulb.
Immediately after the light is turned OFF, the bulb retains high temperature. Make
sure to cool down the light bulb thoroughly before replacing it so as to prevent burns.
CAUTION:
When replacing the light bulb, check the shape of base as well as the rating (12 V, 5 W),
and then carry out perfect mounting. Otherwise, the light bulb can come off and/or
cause overheat.
1. Detaching light bulb
(1) Remove the convex part of the light cover
from the concave part of the housing, and
then pull out the light cover in the arrow-
marked direction as shown in Fig. 21.
(2) Push the back of the socket, and remove
the socket and the light bulb together
from the housing. (Fig. 22)
(3) Remove the light bulb from the socket.
(Fig. 23)
2. Attaching light bulb
Take procedures here that are contrary to
the detaching procedures.
NOTE:
When attaching the light bulb to the
socket, insert the light bulb until it lightly
bumps against the socket.
When attaching the socket to the housing,
align the socket with the hole of housing
while watching the back of the socket
shown in Fig. 23, and insert the socket
until it lightly bumps against the housing.
24
Light Cover
Convex
Concave
Fig. 21 〈Side View〉
Back of the Socket
Fig. 22
Housing
Socket
Fig. 23 〈Top View〉
Housing
Housing
Light Bulb