Hitachi C 6DC2 Instructions De Sécurité Et Mode D'emploi page 14

English
ASSEMBLY AND OPERATION
APPLICATIONS
Cutting Various types of wood.
REMOVAL AND INSTALLATION METHOD OF BATTERY
Handle
Insert
Pull out
CHARGING METHOD
NOTE: Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
Battery
Pilot lamp
14
Push
Latch
Battery
Fig. 5
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn out.
Fig. 6
How to install the battery.
Align the battery with the groove in tool
handle and install it into place.
Always insert it all the way until it locks in
place with a little click, If not, it may
accidentally fall out of the tool, causing injury
to you or someone around you. (Fig. 5)
How to remove the battery.
Withdraw battery from the tool handle while
pressing the latches on both sides of the
battery. (Fig. 5)
1. Insert the plug of battery charger into
the receptacle.
When the plug of battery charger has been
inserted into the receptacle, pilot lamp will
blink in red. (At 1-second intervals)
WARNING:
Do not use the electrical
cord if damaged. Have it
repaired immediately.