Hitachi C 6DC2 Instructions De Sécurité Et Mode D'emploi page 18

English
6. Check for proper operation of the brake.
This circular saw features an electric brake that functions when the switch is released.
Before using the circular saw, ensure that the electric brake functions properly. If it does
not, bring the tool to an Hitachi Authorized Service Center.
7. Prepare a wooden work bench (Fig. 7)
Since the saw blade will extend beyond
the lower surface of the lumber, place the
lumber on a work bench when cutting. If
a square block is utilized as a work bench,
select level ground to ensure it is properly
stabilized. An unstable work bench will
result in hazardous operation.
CAUTION:
To avoid possible accident, always ensure
that the portion of lumber remaining
after cutting is securely anchored or held
in position.
ADJUSTING THE SAW PRIOR TO USE
1. Adjusting the cutting depth (Fig. 8)
WARNING:
To adjust cutting depth, loosen the Wing-
nut and, while holding the base with one
hand, move the main body up and down
to obtain the prescribed cutting depth.
After adjusting to the prescribed cutting
depth, tighten the Wing-nut securely.
2. Adjusting the angle of inclination
WARNING:
18
If the wing-nut is loose,
injury can result. Tighten
it securely after adjust-
ment.
If the wing-nut is loose,
injury can result. Tighten
it securely after adjust-
ment.
Lumber
Work Bench
Fig. 7
Wing-Nut
Base
Fig. 8
Base
Saw Blade