Proper Use; Technical Data; Mains Connection - EINHELL GC-RS 2540 CB Mode D'emploi D'origine

Anleitung_GC_RS_2540_CB_SPK7__ 14.05.14 16:09 Seite 13

3. Proper use

This electric garden refuse shredder is designed only
for shredding organic garden waste. Place biologi-
cally degradable material, e.g. leaves, branches,
dead flowers etc., into the loading funnel inlet.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Voltage:
Power rating:
Cutting unit idling speed
Branch diameter:
L sound pressure level:
pA
K uncertainty
L sound power level:
WA
Weight:
Operating mode S6 40%: Continuous operation with
idling (cycle time 10 minutes). To ensure that the
motor does not become excessively hot it may only
be operated for 40% of the cycle at the specified
rating and must then be allowed to idle for 60% of
the cycle.
●
●
●
●
●
●
●
1. Screw the motor unit (Fig. 4/Item 1) and the base
frame (Fig. 4/Item 3) together. Use the screws
(Fig. 3/Item 12) and washers (Fig. 3/Item 13) to
do so.
2. Fit the wheels to the base frame. To do so, slide
one sleeve each into the hole in each of the
230-240 V ~ 50 Hz
wheels (Fig. 6). Then insert one screw with
washer through each sleeve (Fig. 7) and screw
2500 W (S6-40%)
the wheels to the base frame (Fig. 8). To do so,
2000 W (S1)
fit one washer in front of the tubular rod and one
40 min
-1
behind it. Press the wheel caps onto the wheels
(Fig. 9).
max. 40 mm
3. Fit the legs (Fig. 10/Item 11) to the base frame
80.9 dB (A)
as shown in Fig. 10.
3 dB (A)
4. Slide the shredded material debris box into the
mount with the safety switch (Fig. 12/Item A) at
94 dB (A)
the front as shown in Fig. 11. Ensure that the
30 kg
shredded material debris box runs above the
guide rails (Fig. 4/Item A).
5. Lock the shredded material debris box with
safety switch (Fig. 12/Item A) in position by
pushing upwards.
6. Operation
Please observe the statutory regulations governing
noise abatement during operating times, which may
differ from town to town.

6.1 Mains connection

Connect the device with an extension lead
connected to the integrated power plug (Fig. 13/Item
E). Be sure to observe the relevant information in the
safety instructions.
GB
13