Safety Information; Items Supplied - EINHELL GC-RS 2540 CB Mode D'emploi D'origine

Anleitung_GC_RS_2540_CB_SPK7__ 14.05.14 16:09 Seite 12
GB
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.

1. Safety information

Please refer to the booklet included in delivery for the
safety instructions.
Description of the warning sign (see Figure 17)
on the machine
1: Important! Read the operating instructions and
follow the warnings and safety instructions
2: Take care when the blades are rotating. Do not
put your hands or feet into openings when the
machine is running.
3: Important! Keep other persons and animals away
from the danger zone.
4: Important! Protect the machine from the damp
and never expose it to rain.
5: Important! Always wear safety goggles, ear
muffs, protective gloves and heavy-duty work
clothes!
6: Always set the ON/OFF switch to OFF and pull
the power plug out of the socket-outlet before
doing any work on the shredder, e.g. cleaning
the shredder and making adjustments, or if
the power cable becomes damaged.
7: Explanation of the safety switch on the debris
box:
The switch is in the "Lock is closed" position: The
shredded material debris box is locked. The
shredder can be switched on. The switch is in
the "Lock is open" position: The shredded
material debris box is not locked and can be
removed. The shredder cannot be switched on.
8: Explanation of the lever for adjusting the counter
blade:
Turning clockwise reduces the distance between
12
the cutting unit and the counter blade. Turning
counter-clockwise increases the distance
between the cutting unit and the counter blade.
9. Changeover switch: For a description of the
changeover switch see point 6.4
2. Layout and items supplied (Fig. 1-3)
2.1 Layout
1. Motor unit
2. Shredded material debris box
3. Base frame
4. Wheels
5. Wheel caps
6. Knob for setting the counter blade
7. Integral power plug
8. Transport handle
9. Reverse running switch
10. ON/OFF switch
11. Legs (including fastening screw)
12. 3x screws for fitting the motor unit
13. 3x washers for fitting the motor unit
14. 2x sets of screws for fitting the wheels (including
wheel sleeves, washers and nuts)
15. 2x open-ended spanners (10/13 mm)
16. 1x Philips screwdriver
17. Funnel

2.2 Items supplied

●
●
●
●
●
●
●