Safety Information; Proper Use - EINHELL GT-SA 1200 Mode D'emploi D'origine

Anleitung_GT_SA_1200_SPK1:_
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions and
the safety information.

1. Safety information

Ensure that you observe the following points in order
to avoid accidents and injuries.
Do not overload your swing arm.
Do not continue to use the swing arm if it is
damaged.
Ensure that all bolts are tightly fastened and
check them frequently for your own safety.
Ensure that the cotter pin is properly inserted
through the bore holes.
Lifting and carrying persons with the cable winch
is strictly prohibited! Additionally, persons may
not loiter underneath the cable winch/swing arm
assembly.
Persons who are not aware of these safety
precautions may not use this product.
All components must be regularly checked for any
kind of deformation or damage.
Observe the maximum permissible load capacity
(see „Technical Data")!
09.11.2011 13:32 Uhr Seite 9
2. Layout and items supplied (Fig. 1/2)
1. Pipe collar (with large hinge pin A)
2. 2x holding bars for pipe collars
3. Pipe collar (with small hinge pin B)
4. Support arm
5. Square-edged boom 45 x 45 x 1.8 mm
6. Extension pipe 40 x 40 x 2.5 mm
7. Cotter pin Ø 3 x 45 mm
8. Cotter pin Ø 3 x 60 mm
9. 4x hexagon nuts M10
10. 4x spring washers Ø 10
11. 4x washers Ø 10
12. 2x pads for clamping brackets
13. Hexagon nut M8
14. Spring washer Ø 8
15. Washer Ø 8
16. Hexagon bolt M8 x 15 mm
17. Hexagon bolt M12 x 70 mm
18. Hexagon nut M12
19. Spring washer Ø 12
20. Washer Ø 12

3. Proper use

The swing arm is designed to be attached to a cable
winch. For this, the swing arm must be mounted to a
well fastened steel bar with a diameter of 48 mm.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the manufacturer
will be liable for any damage or injuries of any kind
caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data (Fig. 21)
Reach l:
l = 750 mm m
1
l = 1100 mm m
2
Swing range: max. 180°
GB
Max. load:
= 600 kg
1
= 300 kg
2
9