Télécharger Imprimer la page

Renfert silent EC2 Guide De Démarrage page 24

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 25
There is a risk of increased exposure to dust when replacing the fine filter.
That's why the following measures must be taken:
EN
⇒ Keep the plastic bag ready that contains the new filter.
⇒ Keep an additional dust extraction device or suction tube from another workbench extraction unit ready.
⇒ Wear at least an FFP2 mask for respiratory protection.
⇒ Clean the filter 2x
- Press the Enter key for 2 seconds
- Filter cleaning is carried out
- Repeat the procedure
- Switch off the extraction unit.
⇒ Disconnect the power plug
⇒ Disconnect the suction hoses.
⇒ Place the extraction unit so that it can be turned around.
⇒ Pull out the dust drawer.
⇒ Turn the extraction unit upside down
⇒ Suction the loose dust in the dust room.
⇒ Unlock the clamping nut (1), loosen (2), remove, and ensure
disposal.
⇒ Pull out the fine filter upwards
⇒ Place the fine filters immediately in the plastic bag and seal the
bag tightly to prevent dust escaping.
⇒ Ensure proper disposal.
⇒ Suction any fallen dust out of the dust room and clean room.
⇒ Insert a new fine filter; ensure that it is correctly positioned.
⇒ Attach a clamping nut and tighten as shown.
⇒ Turn the extraction unit back to its previous position.
⇒ Insert the dust drawer.
⇒ Connect the suction hoses, insert the power plug, and place the
extraction unit back in position.
⇒ Use the additional dust extraction device to suction up dust that
has been released.
When installing the fine filter, pay attention to the correct fit, otherwise there will be leakage. Please refer
to the assembly guide at the end of this manual, which is also included with the new fine filter.
Spare Parts
You can find components subject to wear and the spare parts on the spare
part list in the internet at www.renfert.com/p918.
Enter the following item number: EC2: 29370000, TC2: 29360000.
The components excluded from the warranty (such as consumables or parts
subject to wear and tear) are marked on the spare part list.
Disposal Information
Within the European Union, units with this symbol should not therefore be disposed of in unsort-
ed domestic waste.
Please contact your local authorities for more information on proper disposal.
- 8 -
2.
1.
+
2 x
Subject to change

Publicité

loading

Ce manuel est également adapté pour:

Silent tc2