Renfert silent EC2 Guide De Démarrage page 17

Introduction
This Quick Start Guide contains instructions on the operation of the product
and relevant safety information.
Detailed information on the product can be found in the operating instructions
which are available for download on our website at www.renfert.com/p915.
Enter the following item number: EC2: 29370000, TC2: 29360000.
Symbols
In the instructions for use and on the unit itself you will find these symbols with the
following meanings:
Danger
This indicates a direct risk of injury. Consult accompanying documents!
Electrical current
This indicates a risk of hazard due to an electrical current.
Attention
Disregarding this warning may result in damage to equipment.
Note
This provides the operator with useful information to improve and ease use.
The device complies with the requirements of the applicable EU directives.
This product complies with the relevant UK legislation.
See UKCA Declaration of Conformity in the Internet under www.renfert.com.
The device is subject to the EU directive 2002/96/EG (WEEE directive).
Other symbols are explained as they occur.
Safety
Intended Use
This device is designed to extract dry, non-explosive dust.
The unit is intended solely for use in a commercial dental laboratory and dental practice.
The intended use also includes compliance with the instructions specified by the manufacturer concerning
operation, servicing and maintenance.
The extraction unit can be used in combination with a SILENT flow sensor within the scope of measures
to protect against exposure to dust *) as defined by the German ordinance on hazardous substances
("GefStoffV") / respective employers' liability insurance association.
For this purpose, the information on low-dust disposal of the extracted material (chapter "Emptying the
dust drawer") and on low-dust replacement of the fine filter (chapter "Replacing the fine filter") in particular
must be observed.
In doing so, both the instructions for use of the extraction unit as well as those of the SILENT flow
sensor must be observed.
*) Note for customers in Germany: A validated and recognized dust protection measure in accordance with testing
principle GS-IFA-M20 (issued by the German Institute for Work and Health IFA) shall only be deemed to have
been provided when all components, i.e. the flow rate monitoring unit such as the SILENT flow sensor, the ex-
traction unit, and the detection unit, are validated and recognized.
In the case of multi-workbench extraction units and the use of Y-junctions or extractor switches, every suction
channel / every suction point must be fitted with a flow rate monitoring unit.
Improper Use
The equipment is not suitable for use with dental CAM units! For information concerning SILENT
extraction units for CAM machines, please refer to www.renfert.com.
Fire-promoting, easily flammable, red-hot, burning or explosive materials must not be suctioned into the
device. It is not permitted to suction liquids. This device is not intended for private, household use.
Any use other than specified in these instructions is deemed improper and constitutes a misuse of the
device. The manufacturer shall not be liable for damages caused by improper use.
Only spare parts and accessories supplied or authorized by Renfert GmbH may be used with this prod-
uct. If other spare parts or accessories are used, this could have a detrimental effect on the safety of the
device, increase the risk of serious injury and lead to damage to the environment or the device itself.
- 1 -
EN