Publicité
Les langues disponibles
Les langues disponibles
Precautions
w Operating precautions
p
p p This unit is for indoor use only.
It cannot be used outdoors.
Avoid installation in a location where the unit will be
exposed to direct sunlight for extended periods or near a
cooling or heating appliance.
Otherwise, deformation, discoloration, malfunctioning
and/or problems in operation may result. Operate the unit
where it will not be splashed or sprayed by water.
p p Handle the unit carefully. This product uses parts that
may be damaged by improper handling or storage.
p p Do not use this unit in an atmosphere where there are
flammable gases. Otherwise, an explosion may occur,
resulting in injuries.
p p Do not install this unit in a location that is susceptible
to salt damage or where corrosive gases are given off.
Otherwise, the mounting parts will deteriorate, and this
unit may fall, resulting in injury or accidents.
p p Tighten the screws and bolts using the designated
torque. Otherwise, this unit may fall, resulting in injury or
accidents.
p p Install this unit on a surface that can bear its weight.
Otherwise, this unit may fall or topple over, resulting in
injury or accidents. Installation work should be started
only after sufficient reinforcement is completed.
p p Insert the AC plug completely. If the plug is not inserted
completely, fire due to overheating or electric shock may
result. Do not use a damaged plug or loose AC outlet.
p p Do not pull or insert the AC plug if your hands are wet.
Electric shock may result.
p p Do not place containers with water or other liquids on top
of or around the device. If water or other liquids get inside
this unit, a fire or electric shock may result. Immediately
disconnect the power plug, and contact the store where
you purchased this unit.
p p Do not insert foreign objects. If water or metal objects
get inside this unit, a fire or electric shock may result.
Immediately disconnect the power plug, and contact the
store where you purchased this unit.
p p Do not disassemble this product. Otherwise, it may cause
fire or electric shock.
p p Do not do anything that may damage the AC cord or
the AC plug. Do not damage or modify the cord, place
it near hot tools, bend, twist, or pull it forcefully, place
heavy objects on it, or bundle it tightly. Continuing to use
a damaged cord may result in fire, short circuit, or electric
shock. If the cord or plug needs to be repaired, consult
the store where you purchased this unit.
p p Do not attempt to install this unit or proceed with any
connections during a thunderstorm. Otherwise, it may
cause fire or electric shock.
p p Stop operation immediately if the unit emits smoke,
excessive heat or abnormal smell. These conditions can
cause fire or electric shock. Immediately disconnect the
power plug, and contact the store where you purchased
this unit.
p p Do not use this equipment close to an automatic control
equipment like an automatic door fire alarm and so on.
Radio waves from this equipment may cause the trouble
by a malfunction for automatic equipment.
WX-CC411_PGQX2068ZA_IG.indb
9
p p Do not put this product close to a medical equipment.
(Do not bring this product into operating room, intensive
care units (ICU) and coronary care units (CCU).) Radio
waves from this equipment may cause the trouble by a
malfunction for medical equipment.
p p Ask the store where you purchased this unit to do the
installation work. Expertise and experience are required
to install this unit. Otherwise, injuries or damage to this
unit may result. Be sure to ask the store where you
purchased this unit to perform this work.
p p Do not put this product on a place with moisture or dirt.
There is the risk of injury.
Touch panel
p p Perform touch panel operations using only one finger. If
two or more fingers come into contact with the panel at
the same time, the touch panel may not operate properly.
p p Do not use a ballpoint pen or other hard-tipped or sharp
object, including fingernails, to perform touch panel
operations.
p p Do not press on the LCD display with too much force.
p p Do not use any of the LCD protective films available on
the market. (The touch panel may not operate properly.)
p p The inside of the LCD display may become cloudy or
condensation (droplets of water) may form and the
display may not operate properly when the temperature
changes suddenly, such as immediately after air-
conditioning or heating has been turned on. If this
occurs, leave this unit for about one to two hours before
attempting to use it again.
To cut the power supply
This product has no power switch. To cut the power supply,
unplug the power plug of the product from the AC outlet. If
it is hard to unplug the power cord due to the installation
conditions, connect the power cord of the product to the AC
outlet via the circuit breaker of a distribution board or to the
AC inlet socket of a power supply control unit.
Built-in backup battery
Do not expose the built-in backup battery to excessive heat,
such as direct sunlight or fire.
Camera image update speed
The image update speed may be slower, depending on
the network environment used, the number and setting of
cameras, the subjects, and number of accesses.
9
2016/05/18
13:30:25
Publicité
