Panasonic WX-CC411A Mode D'emploi page 21

Installation procedures
w Deciding on where to install the Center Module
p
Select a wall on which to mount this unit, drill a hole in it to pass the wires through, and decide where the four screws are to be
positioned, as shown below.
Important
p p Ensure that the installation surface has the pull-out strength below.
w Installation
p
1
Mount this unit using the accessory wall mounting bracket and 4 screws (4.1 mm × 25 mm
{5/32 inches × 63/64 inches}).
[Minimum pull-out strength: 780 N {80 kgf}]
Screws (locally procured)
(wood screws:
4.1 mm × 25 mm
{5/32 inches × 63/64 inches})
WX-CC411_PGQX2068ZA_IG.indb 21
190
5
200
Wire channel
21
2016/05/18 13:30:37