Télécharger Imprimer la page

Renfert Twister Traduction Du Mode D'emploi D'origine page 32

Masquer les pouces Voir aussi pour Twister:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 36
7.3
Error codes
The following indications will be given if the electronic system detects an error:
en
♦ The mixing operation is canceled�
♦ A warning signal will sound�
♦ The display will flash alternately „Err" and an error code.
End of error display:
⇒ Press control button (except for Err 3, 5 and 6)�
⇒ Err 3, 5 and 6: Switch device off, follow advice in section 5�5�2 "power failure"�
With Err 5 it may no longer be possible to remove the mixing bowl.
With an error code as shown in the following table, please proceed as advised�
Error code
Err. 2
Err. 3
Err. 4
Err. 10
For all other error codes:
⇒ Note error code�
⇒ Have the device repaired�
⇒ Quote the error code to the repair service�
8
Technical data
Mains voltage:
Power consumption:
Device fuse:
Speed:
Connection pressure:
Air consumption, approx:
LpA *) (idling):
Dimensions (W x H x D):
Weight (without bowl) approx:
*) sound pressure level in accord� with EN ISO 11202
Cause
• Minimum vacuum level not yet reached�
• Vacuum level has dropped below 500 mbar�
• The vacuum is built-up too quickly due to the
fact that the suction system is blocked�
• Motor fault�
• Too much material�
• Mixing time too long, the material has al-
ready begun to set�
Twister (No. 1826)
152 x 285 x 235 mm
[6�0 x 11�2 x 9�3 inch]
• Ventilate bowl and remove (see section 5�5�1,
points no� 2 and 3)�
• If the error recurs:
Have the device repaired�
• Have filter cleaned or changed (Sec. 6.3).
• Ventilate bowl and remove (see Sec� 5�5�1,
points no� 2 and 3)�
• Have the device repaired�
• Ventilate bowl and remove (see section 5�5�1,
points no� 2 and 3)�
• Only fill the bowl to the maximum fill level.
This limit is valid for powders and liquids mea-
sured before mixing�
• Ventilate bowl and remove (see section 5�5�1,
points no� 2 and 3)�
• Select shorter mixing times�
100 - 240 V, 50 / 60 Hz
180 VA
T4AL, 250 VAC
100 - 450 1/min
--
--
< 70 db(A)
5,2 kg
[11�5 lbs]
- 14 -
Solution
Twister venturi (No. 1827)
4,5 - 6 bar [65 - 87 psi]
28 l/min
152 x 320 x 235 mm
[6�0 x 12�6 x 9�3 inch]
4,0 kg
[8�8 lbs]

Publicité

loading

Ce manuel est également adapté pour:

Twister venturi18261827