Assa Abloy MSL mFlipLock drive Instructions De Montage Et D'utilisation page 50

Les langues disponibles

All manuals and user guides at all-guides.com

Assembly

Warning!

Inspect for damage:Damage to cables can lead to electric shock. Damage to metal parts can lead to inju-

ries. A damaged lock is a safety risk.

· Never put a damaged device into operation. Never use damaged cables or plug connections.

· Always inspect the packaging and the lock for damage.

Always comply with local building regulations and provisions:Always comply with all building regula-

tions when assembling the lock and electrical connection. Comply with the instructions of the door manu-

facturer.

At tention!

Material damage caused by working on the door leaf:Dismantle and remove the lock when working on

the door leaf, for example when drilling or milling.

· Only use the factory-made drill holes for attaching the door fittings

· Dismantle and remove the lock before working on the door leaf, for example when drilling or milling.

Functional impairment caused by faulty milling of the lock recess:It must be possible to insert the lock

without force and screw it in place without distortion.

· Mill the lock recess according to the lock case dimensions.

Damage caused by dirt: Contamination damages the lock.

· Clean the lock recess and all drill holes by blowing out or vacuuming before installation.

Impaired function caused by distorted installation:All bolts must be able to close without transverse

· Install the lock, all bolts and accessories (strike plate, fittings, lever handle) without distortion.

Material damage caused by forced insertion of the latch pin into the lock follower:It must be possible

to simply push the latch pin of the door handle into the lock follower.

· Do not use any tools to push the latch pin into the lock follower.

Impaired function caused by door handle not moving freely:Install the lock so that the latch pin and the

lock follower are aligned.

Danger of destruction by construction key: The lock function is then no longer guaranteed.

· Use a suitable locking cylinder to operate the lock.

Comply with the power supply tolerances:Exceeding or falling below the tolerance limits will cause

damage and malfunction.

· Measure the lock to verify that the operating voltage is within the stated tolerance limits during nominal

current consumption.

Assembly