Assa Abloy MSL mFlipLock drive Instructions De Montage Et D'utilisation page 44

All manuals and user guides at all-guides.com
Intended use
The mFlipLock drive/e-drive panic/security/multipoint locking system is suitable for installation in single-leaf
or double-leaf tubular frame doors, timber doors or doors with plastic profiles. It is not suitable for
installation in swing doors.
The lock is suitable for door locks in security areas and escape routes according to the following stan-
dards:
· Escape route doors according to EN 179.
· Panic doors according to EN 1125.
· Fire doors or smoke doors according to EN 1634.
· Burglar-proof areas according to DIN 18251-2 class 5 and EN 12209 class 7.
The door must be made of sufficiently rigid material to limit bending during operation to a maximum of
5 mm in each direction. The material must ensure a tensile strength of >1.5 kN per screw.
When used in double-leaf escape route doors, the passive leaf must also be designed as an escape route
door and must be equipped with an approved bolt locking device for wings.
If the passive leaf is not designed as an escape route door, only install the lock in the double-leaf door if the
passive leaf can be secured safely and without play and if the active leaf is stopped by a stop edge.
In double-leaf doors with rebated middle stiles and panic door locks in both leaves, the leaf on which the
panic door lock is actuated must open. Both leafs must open freely when both panic door locks are
actuated simultaneously. It may be necessary to install a pushing flap.
In the case of double-leaf doors with rebated middle stiles and door closers, the doors must close in the
correct sequence to ensure the function of the fire door or smoke door. Therefore a door coordinator
must be fitted.
The lock is suitable for use in fire doors (smoke doors). Observe all applicable regulations for the approval
of safety doors.
Only install the lock in correctly functioning door systems. Observe all applicable regulations for the
complete door system.
The lock cannot be combined with electric door openers.
The lock is suitable for installation in doors with a high usage frequency and little incentive for care in
areas where the possibility of accident or misuse exists (office doors, for example).
All other types of use are regarded as being contrary to the intended purpose.
EN
44
Notes