Normal Maintenance - Edgecraft ChefsChoice 120 Mode D'emploi

No lubrication is required for any moving parts, motor, bearings or sharpening surfaces.
There is no need for water on abrasives. The exterior of the sharpener may be cleaned by
carefully wiping with a damp cloth. Do not use detergents or abrasives.
Once a year or so, as needed, you can remove metal dust that will accumulate inside the
sharpener from repeated sharpenings. Remove the small rectangular clean-out cover
(Figure 14) that covers an opening on the underside of the sharpener. You will find metal
particles adhered to a magnet attached to the inside of that cover. Simply rub off or brush
off accumulated filings from the magnet with a paper towel or tooth brush and reinsert
the cover in the opening. If larger amounts of metal dust have been created or if the Stage
3 disk has been cleaned (using the cleaning/dressing means), you can shake out any
remaining dust through the bottom opening when the cover is removed. After cleaning,
replace the cover securely with its magnet in place.
In the event post-warranty service is needed, return your sharpener to the EdgeCraft
factory where the cost of repair can be estimated before the repair is undertaken. Outside
the USA, contact your retailer or national distributor.
Please include your return address, daytime telephone number and a brief description of
the problem or damage on a separate sheet inside the box. Retain a shipping receipt as
evidence of shipment and as your protection against loss in shipment.
825 Southwood Road, Avondale, PA 19311 U.S.A.
Assembled in the U.S.A.
This product may be covered by one or more EdgeCraft patents and/or patents pending as marked on the
product. Chef'sChoice®, EdgeCraft®, Diamond Hone®, EdgeSelect® and the overall design of this product are
registered trademarks of the EdgeCraft Corporation.
Conforms to UL Std. 982
© EdgeCraft Corporation 2018
K18

NORMAL MAINTENANCE

SERVICE
EdgeCraft Corporation
Consumer Support 1-800-342-3255
Certified to CAN/CSA Std. C22.2 No. 64
Certified to EN 60335-1, EN 60335-2, EN 55014-1+A1, EN 61000-3-2, EN 61000-3-3
E/F/S
English — 12
chefschoice.com
Printed in China.
C1283Z3