Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
B
pOwER SuppLy
INSERT / CHARGE THE BATTERY
Open the battery compartment cover and insert the Li-Ion battery. Close the battery compartment
cover.
The battery status will be displayed by the ON/OFF LED of the laser: When the LED starts flashing
the battery must be recharged.
To charge the battery, remove it from the laser and charge it outside of the instrument. When the
battery is fully charged, insert it again. The red LED at the battery shows that it is being charged.
When the charging is completed the LED will extinguisch.
Permanent power supply:
Connect the charging socket of the laser with the USB cable and the charger and connect it with
a plug socket.
12
ON/OFF LED
Publicité
Table des Matières
