Listening To The Radio; Tuning In To A Station-Auto Search; Presetting Stations; Tuning In To A Preset Station - JVC MX-GC5 Manuel D'instructions

Listening to the Radio

Tuning in to a Station—Auto Search
1
Press FM/AM.
The unit automatically turns on and tunes in to
the previously tuned station (either FM or AM).
• Each time you press the button, the band
alternates between FM and AM.
2
Start searching for stations.
On the remote control:
Press and hold ¢/¡ or
4/1 for more than 1
second.
On the unit:
Press and hold
TUNING + or TUNING
– for more than 1 second.
The unit starts searching for stations and stops when a
station of sufficient signal strength is tuned in.
If a program is broadcast in stereo, the ST (stereo)
indicator lights up.
To stop while searching, press ¢/¡ or 4/1 (or
TUNING + or TUNING – on the unit).
When you press ¢/¡ or 4/1
(or TUNING + or TUNING – on the unit) briefly and
repeatedly
The frequency changes step by step.
To change the FM reception mode
When an FM stereo broadcast is hard to receive or
noisy, press FM MODE on the remote control so
that "MONO" appears and the MONO indicator
also lights up on the display. Reception improves.
To restore the stereo effect, press FM MODE again so that
"STEREO" appears on the display.

Presetting Stations

You can preset 30 FM and 15 AM stations.
In some cases, test frequencies have been already memorized
for the tuner since the factory examined the tuner preset
function before shipment. This is not a malfunction. You can
preset the stations you want into memory by following the
presetting method.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 2 again.
On the remote control ONLY:
1
Tune in to the station you want to preset (in
this example, of FM 87.5).
• See "Tuning in to a Station—Auto Search."
13
2
Press SET/RESUME on the remote
control.
3
Press the number button(s) to
select a preset number.
Ex.: For preset number 5, press 5.
For preset number 15,
press +10 then 5.
For preset number 20,
press +10, then 10.
For preset number 25, press +10, +10, then 5.
For preset number 30, press +10, +10, then 10.
4
Press SET/RESUME on the remote
control again.
The tuned station in step 1 is stored in the preset number
selected in step 3 .
• Storing a new station on a used number erases the
previously stored one.
When you unplug the AC power cord or if a power
failure occurs
The preset stations will be erased in a few days. If this happens,
preset the stations again.

Tuning in to a Preset Station

1
Press FM/AM.
The unit automatically turns on and tunes in to
the previously tuned station (either FM or AM).
• Each time you press the button, the band
alternates between FM and AM.
2
Select a preset number.
On the remote control:
Press the number buttons.
Ex.: For preset number 5, press 5.
For preset number 15,
press +10 then 5.
For preset number 20,
press +10, then 10.
For preset number 25, press +10, +10, then 5.
For preset number 30, press +10, +10, then 10.
On the unit:
Turn PRESET +/– control to
select a preset number.