Use Of The Fm Radio; Rds Functions; Saving Stations In Station Memory - JVC UX-C25BT Mode D'emploi

Use of the FM radio

Press the button on the remote control or the
FM
appears on the display.
Setting a FM station
• Press the button on the remote control to increase the reception frequency.
TUN+
• Press the button on the remote control to lower the reception frequency.
TUN-
• If you hold down the
first station which is found.
• Press the Auto button to start a station scan with automatic storage of the stations which are found.
A maximum of 30 stations will be stored in the order they were found.
• Press the or
memory list. Memory spaces which are unassigned will be indicated with "EMPTY".
Use of Radio Data System (RDS)
RDS is a transmission system whereby FM station transmit other useful information along with the
actual transmitter signal. This can be extracted from the normal transmitter signal and used for a range
of additional functions.
If an RDS signal is received, then"RDS" appears in the display below the frequency display and
after a while the station name and other information is displayed instead of the frequency.

RDS functions

The following information can be retrieved by repeatedly pressing the
• Radiotext – If the station is not broadcasting any radio text, then "NO TEXT" appears.
• PTY (Program Type) – If the station is not broadcasting any PTY signal, then "NONE" appears.
• Frequency and memory space of the station received
• Stereo / Mono display
• Time – If the station is not broadcasting any time signal, then "00_00_00" appears.
• Date – If the station is not broadcasting any date signal, then "00-00-00" appears.
If there is insufficient reception signal, signal reception can be disturbed or impossible despite
showing "RDS" display.

Saving stations in station memory

There are 40 memory spaces available to make it easier to find FM stations.
To assign the memory, proceed as follows:
• Select a station to be saved
• Press the button until a station memory space flashes in the display. An empty memory space
PRG
is indicated by "EMPTY", an assigned space is shown with its frequency. You can also re-assign a
memory space which is already in use.
• Press the or buttons to select a memory space.
• Confirm or
flashing.
• The stations can now be selected with the
27.0 mm
4.5 mm
TUN+ or TUN- buttons, an automatic station scan starts which stops at the
buttons on the remote control or on the main device to scroll through the
save using the button. The preset memory number will no longer be
PRG
button on the main device until "FM"
or buttons.
button:
RDS
13