Safety During Installation; Preparation For Motor Mounting - BFT IANUS BT 300 Kit Instructions D'utilisation Et D'installation

SAFETY DURING INSTALLATION

During installation, please:
- use appropriate tools as specified by these instructions�
- use personal protection equipment (protective goggles, gloves) when working�
- mark work in progress and do not leave the site unattended�
- do not connect the electrical mains until assembly is completed�
- once the equipment is connected to the mains, only touch buttons and adjustment devices necessary to program the unit�
- work and repairs not specified in these instructions are not authorised�

PREPARATION FOR MOTOR MOUNTING

Use a base plate as a template and drill a hole at least 60mm deep with a Ø10 mm drill bit� Insert the dowels with a plastic hammer�
Dowels should protrude about 85 mm�
Dowel holes
should be at least
70 mm deep�
Align the plate with a level so that the motor is even, then place the motor on the plate�
32
- IANUS BT 300 KIT - IANUS BT 500 KIT
> 25mm 85mm
> 10mm