User Warnings; General Safety - BFT IANUS BT 300 Kit Instructions D'utilisation Et D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

USER WARNINGS ( I )
WARNING! Important safety instructions� Care-
fully read and comply with the Warnings and
Instructions that come with the product as im-
proper use can cause injury to people and animals
and damage to property� Keep the instructions
for future reference and hand them on to any
new users�
This product is meant to be used only for the
purpose for which it was explicitly installed�
Any other use constitutes improper use and,
consequently, is hazardous� The manufacturer
cannot be held liable for any damage as a result
of improper, incorrect or unreasonable use�

GENERAL SAFETY

Thank you for choosing this product� The Firm is
confident that its performance will meet your op-
erating needs�
This product meets recognized technical standards
and complies with safety provisions when installed
correctly by qualified, expert personnel (professional
installer)�
If installed and used correctly, the automated system
will meet operating safety standards� Nonetheless,
it is advisable to observe certain rules of behaviour
so that accidental problems can be avoided:
- Keep adults, children and property out of range of
the automated system, especially while it is moving�
- Do not allow children to play or stand within range
of the automated system�
- This automated system is not intended to be used
by children or by individuals with reduced men-
tal, physical or sensory abilities, or by individuals
without adequate know-how unless supervised or
instructed on equipment use by the individual in
charge of their safety�
- Children should be supervised to ensure they do
not play with the equipment� Do not let children
play with the fixed controls� Keep remote controls
out of reach of children�
- Do not work near hinges or moving mechanical parts�
- Do not hinder the leaf's movement and do not at-
tempt to open the door manually unless the actuator
has been released with the relevant release knob�
- Keep out of range of the motorized door or gate
while they are moving�
- Keep remote controls or other control devices out
of reach of children in order to avoid the automated
system being operated inadvertently�
- The manual release's activation could result in un-
controlled door movements if there are mechanical
faults or loss of balance�
- When using roller shutter openers: keep an eye
on the roller shutter while it is moving and keep
people away until it has closed completely� Exercise
care when activating the release, if such a device
is fitted, as an open shutter could drop quickly in
the event of wear or breakage�
- The breakage or wear of any mechanical parts of
the door (operated part), such as cables, springs,
supports, hinges, guides..., may generate a hazard�
Have the system checked by qualified, expert per-
sonnel (professional installer) at regular intervals
according to the instructions issued by the installer
or manufacturer of the door�
- When cleaning the outside, always cut off mains
power�
46
- IANUS BT 300 KIT - IANUS BT 500 KIT
- Keep the photocells' optics and illuminating in-
dicator devices clean� Check that no branches or
shrubs interfere with the safety devices�
- Do not use the automated system if it is in need of
repair� In the event the automated system breaks
down or malfunctions, cut off mains power to the
system; do not attempt to repair or perform any
other work to rectify the fault yourself and instead
call in qualified, expert personnel (professional
installer) to perform the necessary repairs or main-
tenance� To allow access, activate the emergency
release (where fitted)�
- If any part of the automated system requires direct
work of any kind that is not contemplated herein,
employ the services of qualified, expert personnel
(professional installer)�
- At least once a year, have the automated system, and
especially all safety devices, checked by qualified,
expert personnel (professional installer) to make
sure that it is undamaged and working properly�
- A record must be made of any installation, main-
tenance and repair work and the relevant docu-
mentation kept and made available to the user on
request�
- Failure to comply with the above may result in
hazardous situations�
SCRAPPING
Materials must be disposed of in accordance
with the regulations in force� Do not dispose of
the used equipment or batteries in domestic
waste� You are liable for returning your elec-
tric or electronic waste to a collection site
dedicated to their recycling�
Anything that is not explicitly provided for in
the user manual is not allowed� The operator's
proper operation can only be guaranteed if the
instructions given herein are complied with� The
Firm shall not be held liable for damage caused
by failure to comply with the instructions fea-
tured herein�
While we will not alter the product's essential
features, the Firm reserves the right, at any time,
to make those changes deemed opportune to
improve the product from a technical, design or
commercial point of view, and will not be required
to update this publication accordingly�

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ianus bt 500 kit

Table des Matières