Benning CC 1 Notice D'emploi page 10

Conversion factor: 1 mV AC = 1 A AC
(see housing with label field  )
Example:
Voltage value indicated on multimeter: 0.350 V AC = 350 mV AC,
corresponds to a measured current value of 350 A AC.
9. Maintenance

Before opening the BENNING CC 1, make sure that it is
disconnected from all voltages! Electrical danger!
Work on the opened BENNING CC 1 under voltage may be carried out only by
skilled electricians with special precautions for the prevention of accidents.
Make the BENNING CC 1 voltage free as follows before opening the
instrument:
- First remove the BENNING CC 1 from the measuring object.
- Then disconnect the two safety measuring cables from the multimeter.
The clamp-on adapter BENNING CC 1 has neither a battery nor a fuse so that
as a rule it does not need to be opened.
9.1 Securing the instrument
Under certain circumstances safe operation of the BENNING CC 1 is no longer
ensured, for example in the case of:
- Visible damage of the casing.
- Incorrect measurement results.
- Recognisable consequences of prolonged storage under improper
conditions.
- Recognisable consequences of extraordinary transportation stress.
In such cases the BENNING CC 1 must be disconnected from the measuring
point immediately and secured to prevent further utilisation.
9.2 Cleaning
Clean the casing externally with a clean dry cloth (exception: special cleaning
wipers). Avoid using solvents and/or scouring agents for cleaning the
instrument.
09/ 2003
BENNING CC 1

8