EdilKamin DEMY Installation, Usage Et Maintenance page 37

PELLET OPERATION
Commissioning must be done by a Technical Service Centre
authorised by Edilkamin (CAT) prior to ignition and testing
according to the UNI 10683/2012 standard.
This standard indicates the control operations to be carried out,
aimed at ascertaining correct system function.
The CAT will also provide for calibrating the stove on the
basis of the type of pellets and the installation conditions, thus
allowing for the effectiveness of the guarantee.
If the fi rst ignition is not carried out by a C.A.T. authorised by
Edilkamin, the guarantee shall not be effective.
For information, consult the website www.edilkamin.com
There may be a slight smell of paint the fi rst few times it is
ignited, however, this will disappear quickly.
Before igniting you must check:
• that installation is correct
• the power supply
• that the door closes properly to a perfect seal
• that the display is on standby (the date, power or temperature
fl ashes).
NOTE:
DURING pellet operation, you can load wood.
The stove automatically recognizes the change of fuel and
changes the operating mode from pellets to wood (The sta-
tus LED changes from RED to fl ashing GREEN/RED).
FILLING THE PELLET HOPPER
Open the two doors A and B to access the hopper (Fig. 1).
N.B.
1) During this operation, the bag of pellets MUST NEVER
be placed on the upper grill, otherwise the plastic bag,
coming into contact with the heat, could ruin the paintwork
on the top.
2) Use the special glove provided if you load the stove while
it is functioning and therefore hot.
NOTE regarding the fuel: pellet.
DEMY is designed and programmed to burn wood pellets with
6 mm diameter.
Pellets are a type of fuel in the form of little cylinders, made
from compacted sawdust, compressed under high pressure
with no adhesives or foreign materials.
They are sold in bags of 15 kg.
For the stove to function properly, you MUST NOT burn
anything else in it.
Such use is detected by laboratory analyses. Edilkamin has
designed, tested and programmed their stoves to guarantee the
best performance when pellets with the following characteri-
stics are used:
diameter: 6 millimetres
maximum length: 40 mm
INSTRUCTIONS FOR USE
(LED RED)
fi g. 1
FRONT HOT AIR DEFLECTOR
It's possible to fl ow hot air from the front using the defl ector
supplied.
Install the defl ector in the rear part of the stove (fi g.1/a) using 4
screws already installed on the structure frame.
fi g. 1/a
maximum moisture content: 8%
calorifi c value: at least 4100 kcal/kg.
If pellets with different characteristics are used, the stoves
must be recalibrated using a similar procedure to that carried
out by the DEALER when the stove is ignited the fi rst time.
Using unsuitable pellets may: decrease effi ciency; cause
malfunctions; stop the stove from functioning due to clogging,
dirt on the glass, unburnt fuel, etc.
A simple, visual analysis of the pellets may be carried out:
Good quality: smooth, uniform length, not very dusty.
Poor quality: with longitudinal and transverse cracks, very
dusty, various lengths and mixed with foreign matter.
- 37
-
A
B