Kohler K-1913 Guide D'installation page 26

Masquer les pouces Voir aussi pour K-1913:

Les langues disponibles

Water Inlet

Nut

and O-Ring

Drain Valve

15. Connect the Components

All Installations

NOTE: Depending upon disassembly, some of these components may still be connected.

Conﬁrm the O-ring is in place and connect the water inlet to the drain valve by tightening the nut.

If an Uninterruptible Power Supply (UPS) has been installed, connect the power following the

directions supplied with the UPS

Connect the drain valve power at the controller, J2.

Connect the level sensing wires at the controller, J3.

Connect the limit switches at the controller, J4.

NOTE: Port J5 should remain unused.

Connect the door power at the controller, J6 and J7.

1128532-2-C

Connect to controller, J2.

Attach the drain.

Connect the drain valve power.

Connect level sensing wires.

Connect limit switch wires.

Connect door power.

Open

Controller

and

Kohler Co.