Kohler K-1913 Guide D'installation page 20

Drain Line
Pulley
Assembly
Drip Tray
Install, route and secure
accumulator drain line
to drip tray.
Approximately
1/4" (6 mm)
clearance required
from drip tray.
11. Install the Drip Tray
All Installations
Install the drain to the drip tray following the drain manufacturer's instructions.
When Reassembling the Bath:
NOTE: These steps are not required if the drip tray was not removed in a previous step. If the drip tray is
already assembled, go to "All Installations" below.
Install the drain to the drip tray following the drain manufacturer's instructions.
Carefully move the drip tray into position, rotating it up and in.
Reconnect the drip tray to the frame using the existing holes and screws that were removed
previously.
IMPORTANT! Make sure the drip tray and pulley assemblies do not contact each other. If the drip tray
and pulley assembly come in contact with each other, remove the drip tray, remove any obstructions with
subfloor, and reposition the drip tray as needed.
IMPORTANT! Cover the drip tray with protective material to avoid damaging it.
All Installations
Connect the drain to the drain outlet.
Route the accumulator drain line loosely through the cable tie attached to the drip tray. Locate the
outlet of the drain line directly over the drain, with a minimum 2-1/2" (6.4 cm) air gap.
IMPORTANT! Cover the drip tray with protective material to avoid damaging it.
1128532-2-C
Clamp
Cable
Tie
2-1/2" (6.4 cm) Minimum Air Gap
Board
Strainer Body
Install drain and attach to drip tray.
20
Accumulator
Drain Line
Kohler Co.