Preparations For Operation Turning The Power On; Turning The Power Off - JVC GY-DV300 Manuel D'instructions

PREPARATIONS FOR OPERATION
1.
Slide the POWER switch to "ON".
Power is now supplied to the unit.
The GY-DV300 operation mode when the power is turned ON will differ depending on the setting
of the MODE switch as described in the following:
MODE Switch
"CAM-A" or "CAM-B"
VTR

Turning the Power OFF

1.
Place the GY-DV300 in the recording-standby or STOP mode.
2.
Slide the POWER switch to "OFF".
3.
Remove the battery pack or the power supply to the DC INPUT connector. (When the GY-DV300 is
not going to be used for at long time.)
CAUTION:
• Do not set the POWER switch to "OFF" while recording is taking place.
Confirm that the STBY or STOP indication is shown in the VTR operation mode indication area
before the power is turned off.
Should the POWER switch accidentally be set to "OFF" during a recording, wait at least 5 seconds
before turning the power on again.
• Before the power supply is disconnected, be sure to set the GY-DV300's POWER switch to "OFF". If
the battery is removed or the power supply from the AC adapter is disconnected while the GY-
DV300's POWER switch is set to "ON", the manual mode operation setting values (IRIS, zoom, gain,
shutter speed, white balance, etc.) are not backed up.
The GY-DV300 starts up be in the shooting mode. The camera image
appears in the viewfinder or on the LCD screen. When a recordable
videocassette is loaded, the GY-DV300 enters the recording-standby
mode automatically. "STBY" is displayed in the VTR operation mode
indication area on the LCD screen and the viewfinder screen.
In this condition, press the REC START/STOP button to start recording.
The GY-DV300 starts up in the VTR playback mode. The camera image
does not appear in the viewfinder or on the LCD screen. If videocassette
is loaded, the mode will be the STOP mode. "STOP" is indicated in the
section for displaying the VTR operation mode on the LCD screen or
viewfinder screen.
Turning the Power ON
MODE
switch
POWER
OFF
ON
MODE
CAM-B
CAM-A VTR
GAIN
SHUTTER
BAR
MENU
AW
FWD
AUDIO
CH-1 CH-2
MIC1
MIC2
REV
MONITOR
CH-1 CH-2
MIX
Operation Mode
POWER
switch
PUSH
E-37