Connecting The Power Supply - JVC 3-CCD KY-F550 Mode D'emploi

2. Preparation Before Shooting (continued)

Connecting the Power Supply

Connect the [DC IN] terminal at the back of this unit to the [TO CAMERA] terminal of the AC adaptor (AA-
P700) using the power cable supplied (2 m).
AC IN
Plug
Notes
● Ensure to make use of AA-P700 for the power supply.
When connecting, ensure that power switch of AA-P700 is turned OFF.
Connecting with the power on may give rise to malfunction of the equipment.
● When power is supplied, it takes several seconds before this unit is operable.
When the "SHUTTER" item under "EXPOSURE" screen is set to "SLOW", it might take even longer time.
● Allow a 10 second interval after switching off the power before turning on again. If the power switch is
turned ON and OFF too soon, malfunctioning such as startup failure may occur.
E-18
AA-P700 AC Adapter
DC 12V=OUTPUT
AC 230 V
S(Y/C) OUTPUT TO CAMERA
EITHER
OUTPUT
MAX 1.25A
White Marking
Connect the end with
white marking to the
AC adaptor.
Ring
RGB, Y/C, SYNC OUT
VIDEO OUTPUT
LENS
TRGGER
SEE INST-
RUCTION
MANUAL
[TO CAMERA] Terminal
Power Cable (2 m)
(accessories)
● Insert plug fully, turn ring and ensure
that it is fastened.
DV
VIDEO OUT
POWER
DC IN
REMORT
SEE INSTRUCTION MANUAL
[DC IN]
Terminal