Setting And Adjustment During Shooting; External Monitor Adjustment - JVC 3-CCD KY-F550 Mode D'emploi

3. Setting and Adjustment During Shooting

External Monitor Adjustment

Display the built-in colour bars signal at the camera on the monitor to perform colour/contrast/brightness
adjustment.
2.
[BARS]
5 / BARS
1 2 3 4
MENU SET
∞/ AW
Switch 4: [OFF]
RGB, Y/C, SYNC OUT
LENS VIDEO OUT
TRGGER
REMORT
SEE INSTRUCTION MANUAL
3.~7.
1 2 3 4 5
1.
Connect the colour video monitor to the [VIDEO OUT] of this
unit.
Make sure that the Switch 4 located at the side of this unit is
set to [OFF] (lower side).
2.
Press the [BARS] button to output the colour bars signal (EBU-
compliant colour bars).
3.
With the colour bars displayed, turn [BLUE CHECK] at the
monitor to ON. Screen turns into a monochrome of blue and
colour bars appear as blue stripes.
4.
Turn the [CHROMA] adjustment knob on the monitor and
DV
adjust colour bars
5.
With [BLUE CHECK] in the ON mode, turn the [PHASE] ad-
1.
justment knob on the monitor to adjust colour bars
POWER
to the same brightness level.
DC IN
6.
If brightness of colour bars
justment, repeat chroma adjustment as in step 4. .
7.
Turn [BLUE CHECK] at the monitor to OFF and return to the
normal screen (R. G. B are all displayed).
6 7 8
1 7
and to the same brightness level.
1 7
and vary upon [PHASE] ad-
3 5
and
E-21