JVC 3-CCD KY-F550 Mode D'emploi page 29

White Spot Correction (continued)
White Spots Correction Messages
Detecting Screen
PIXEL
EXE
PIXEL
ERROR : LENS NOT CLOSED?
Notes
● The white spot correction feature of this unit does not correct all white spots. Detection and correction of
white spots by this unit is performed under the following conditions. White spot correction will not be
performed under conditions beyond those stated. In cases where conditions are fulfilled, correction may
not be successfully performed depending on the nature of the white spots.
In such case, perform the detection again until white spots are detected.
Consult your JVC authorized dealer if white spots cannot be corrected.
Quantity of Detection/Correction: 32 or less
● The screen on the right may be displayed during detection of white spots
in cases when light enters the CCD during detection or depending on the
condition of white spots. In this case, check if there is light entering the
CCD.
● During white spot correction, pixel data is obtained via interpolation of
pixel information from the surroundings. Thus data may not be accurate
for fine images.
● Results of white spot detection will be stored until the next detection is
performed.
● During white spot detection, operation via the remote control will be disa-
bled.
COMPE N
CU T I NG
Detection Error Screen
COMPE N
Detection Completed Screen
PIXEL
COMPE N
OK
TURN POWER OFF
AND ON AGAIN.
COMPE N
PIXEL
ERROR : COUNT OVER
TURN POWER OFF
AND ON AGAIN.
PIXEL
ERROR : LENS NOT CLOSED?
PIXEL
ERROR : COUNT OVER
TURN POWER OFF
AND ON AGAIN.
N
COMPE
COMPE N
E-29