Introduction; Main Technical Specifications - Scale House ATM Mode D'emploi

1. INTRODUCTION

This manual was created to help you install and learn all about the functional possibilities of the ATM and ATMI scales.
The scales should be sited in a location that will not degrade the accuracy.
Avoid extremes of temperature. Do not place in direct sunlight or near air conditioning vents.
Avoid unsuitable tables. The tables or floor must be rigid and not vibrate. Do not place near vibrating machinery.
Avoid unstable power sources. Do not use near large users of electricity such as welding equipment or large motors.
Avoid air movement such as from fans or opening doors. Do not place near open windows.
Keep the scales clean.
Do not stack material on the scales when they are not in use.
FOR ATM MODEL: Avoid high humidity that might cause condensation. Avoid direct contact with water. Do not spray or
immerse the scales in water.

2. MAIN TECHNICAL SPECIFICATIONS

Model
ATM6 / ATMI6
ATM15 / ATMI15
ATM25
Stabilisation Time
Operative Temperature:
Power supply:
Battery life:
Recharge time:
Parameter Setup:
Display :
Case:
Zero range:
Auto zero at start-up:
Plate Capacity
dimensions
mm
190x230
190x230
190x230 15/25
2 Seconds typical.
0°C - 40°C / 32°F - 104°F.
with fitted 240 Vac mains power adapter or with fitted battery
up to 70 hours of continuous use.
12 hours.
Calibration fully digital and programmable from the keyboard.
LCD backlit with 5 digits 24 mm high
ATM: ABS Plastic.
ATMI: IP65 stainless steel.
+/- 2% of max load capacity.
+/- 10% of max load capacity.
WARNINGS
Standard
Division
kg g
3/6 1/2
6/15 2/5
5/10
4
CE-M
Division
g
1/2
2/5
5/10
.