Visualisation With Sensitivity Times 10; Set-Up Environment; Set-Up Environment Block Diagram - Scale House ATM Mode D'emploi

The values vary among:
00 DISABLED
03 3 minutes
05 5 minutes
15 15 minutes
30 30 minutes

6.9 VISUALISATION WITH SENSITIVITY TIMES 10

It's possible to use this function as a test in the calibration phase.
Keep the TARE and ZERO keys pressed for three seconds and release: the display will show the weight with the
minimum division times 10 (a blinking digit is added).
After about 5 seconds the display will return in the standard mode.

7. SET-UP ENVIRONMENT

The scale has various parameters that can be configured in the SET-UP environment.
Enter in the SET-UP environment by keeping pressed TARE key at start –up until display shows the first step "F0 CAL".
- Pressing ZERO will cycle through the other functions.
- Pressing TARE will allow you to get into the function.
- Select a value by pressing the ZERO key or
- Set a numeric value, using the TARE key to increase the value of the digit, the ZERO key to go on the following digit and
confirm on last digit with the ZERO key.
- Press the TARE key to confirm the modification and pass to the following step.
- To exit from the set-up, press the ON/OFF key.

7.1 SET-UP ENVIRONMENT BLOCK DIAGRAM

SETUP
ENVIRONMENT
In the parameter description:
- The METRIC parameters are shown with the (*) symbol, and, with approved instrument, these are read only.
F0 CAL
r 3000, r 6000,
F1 inC
F2 inP
bk of, bk on,
F3 bK
F4 oFF 0, 3, 5, 10, 20
F5 CAP
F6 rE ZEro
F7 SPEED
F8 rSt
F9 GrAV
r dual
bk AU
Pn--- 3, 6, 15, 25
0.5d, 1d,
2d, 4d
7.5, 15, 30
9,XXXXX
12