Checking Quantities; Setting The Weight Thresholds; Visual Indication Of The Check; Unit Of Measure Conversion - Scale House ATM Mode D'emploi

6.6 CHECKING QUANTITIES

The scale is fitted with the quantity check function with 2 thresholds. Messages on the display are enabled on the
basis of the set thresholds and the weighing result.
The check can be made on the weight or on the pieces.
To check the pieces one should execute the reference operation (see section 6.5) and then configure the thresholds.
6.6.1 SETTING OF THE WEIGHT THRESHOLDS
Press TARE and ZERO together:
- The display shows "LOW" and after "000.000", with the first blinking digit. In this step one configures the lower
threshold.
- Use the TARE key to increase the value of the digit and the ZERO key to go on the following digit.
- Confirm the entered value with ZERO.
- The display shows "HIGH" and after "000.000", with the first digit blinking. In this step one configures the upper
threshold.
- Use the TARE key to increase the value of the digit and the ZERO key to go on the following digit.
- Confirm the entered value with ZERO.
- The thresholds are configured and the indicator returns to weighing.
6.6.2 VISUAL INDICATION OF THE WEIGHT CHECK
Put a weight on the plate of the scale.
The indication message will enable depending on which thresholds have been configured:
WITH BOTH THRESHOLDS CONFIGURED
- The HI message of the LCD display will appear when the detected weight exceeds the UPPER THRESHOLD.
- The OK message of the LCD display will appear when the detected weight is between the LOWER THRESHOLD
and the UPPER WEIGHT THRESHOLD.
- The LO message of the LCD display will appear when the detected weight is less than the LOWER
THRESHOLD.
WITH THE UPPER THRESHOLD CONFIGURED AND THE LOWER THRESHOLD = 0
- The OK message of the LCD display will appear when the detected weight exceeds the UPPER THRESHOLD.
- The LO message of the LCD display will appear when the detected weight is less than the UPPER THRESHOLD.
WITH THE UPPER THRESHOLD = 0 AND THE LOWER THRESHOLD CONFIGURED
- The HI message of the LCD display will appear when the detected weight exceeds the LOWER THRESHOLD.
- The OK message of the LCD display will appear when the detected weight is less than the LOWER
THRESHOLD.
NOTES
- The weight check function is enabled when the limit values are entered. To disable the function one should press
again TARE and ZERO key together.
- The function is not valid when one enters a lower limit greater than the upper limit.
- The weight check is enabled with a weight greater than the minimum weight (20d).

6.7 UNIT OF MEASURE CONVERSION

By pressing at length the TARE key the conversion from kg to g takes place; the relative symbol will turn on in the
display (see section 5).
NOTE:
- The function is not available if the counting function is enabled.
- With APPROVED instrument the weight in secondary units is displayed for 5 seconds, after which the display goes
to the scale unit of measure.

6.8 FUNCTION OF AUTOMATIC TURN-OFF

The scale is fitted of a programmable automatic turn-off function, which allows to save energy in case of not using it
temporarily; the automatic turn-off starts functioning when the scale is unloaded (gross weight = 0) for the time (in
minutes) programmed (see step "F4 oFF", section 7.1).
11